__ __ _ _
| \/ | __ _ _ ____ _____| | |
| |\/| |/ _` | '__\ \ / / _ \ | |
| | | | (_| | | \ V / __/ | |
|_| |_|\__,_|_| \_/ \___|_|_|
_ _ ____ _
| | | | | __ ) ___ ___ | |_
| | | |___| _ \ / _ \ / _ \| __|
| |_| |___| |_) | (_) | (_) | |_
\___/ |____/ \___/ \___/ \__|
** MARVELL BOARD: SHEEVA PLUG LE
U-Boot 1.1.4 (Jul 19 2009 - 16:03:28) Marvell version: 3.4.19
U-Boot code: 00600000 -> 0067FFF0 BSS: -> 006CFB00
Soc: 88F6281 A0 (DDR2)
CPU running @ 1200Mhz L2 running @ 400Mhz
SysClock = 400Mhz , TClock = 200Mhz
DRAM CAS Latency = 5 tRP = 5 tRAS = 18 tRCD=6
DRAM CS[0] base 0x00000000 size 256MB
DRAM CS[1] base 0x10000000 size 256MB
DRAM Total size 512MB 16bit width
Addresses 8M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (8M - 7M): Done
NAND:512 MB
Flash: 0 kB
CPU : Marvell Feroceon (Rev 1)
Streaming disabled
Write allocate disabled
USB 0: host mode
PEX 0: interface detected no Link.
Net: egiga0 [PRIME], egiga1
Hit any key to stop autoboot: 0
SDHC found. Card desciption is:
Manufacturer: 0x27, OEM "PH"
Product name: "SD04G", revision 2.0
Serial number: 2084570541
Manufacturing date: 12/2009
CRC: 0x00, b0 = 0
reading kernel.bin
3217780 bytes read
## Starting application at 0x00900000 ...
KDB: debugger backends: ddb
KDB: current backend: ddb
Copyright (c) 1992-2011 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
FreeBSD 8.2-RELEASE-p2 #2: Wed Jun 1 12:05:37 UTC 2011
nils@drm-pcbsd:/usr/obj/arm/usr/src/sys/SHEEVAPLUG-enhanced arm
CPU: Feroceon 88FR131 rev 1 (Marvell core)
DC enabled IC enabled WB enabled EABT branch prediction enabled
16KB/32B 4-way Instruction cache
16KB/32B 4-way write-back-locking-C Data cache
real memory = 536870912 (512 MB)
avail memory = 520138752 (496 MB)
SOC: Marvell 88F6281 rev A0, TClock 200MHz
mbus0: <Marvell Internal Bus (Mbus)> on motherboard
ic0: <Marvell Integrated Interrupt Controller> at mem 0xf1020200-0xf102023b on mbus0
timer0: <Marvell CPU Timer> at mem 0xf1020300-0xf102032f irq 1 on mbus0
timer0: [FILTER]
rtc0: <Marvell Integrated RTC> at mem 0xf1010300-0xf1010307 on mbus0
gpio0: <Marvell Integrated GPIO Controller> at mem 0xf1010100-0xf101011f irq 35,36,37,38,39,40,41 on mbus0
gpio0: [FILTER]
gpio0: [FILTER]
gpio0: [FILTER]
gpio0: [FILTER]
gpio0: [FILTER]
gpio0: [FILTER]
gpio0: [FILTER]
uart0: <16550 or compatible> at mem 0xf1012000-0xf101201f irq 33 on mbus0
uart0: [FILTER]
uart0: console (115740,n,8,1)
uart1: <16550 or compatible> at mem 0xf1012100-0xf101211f irq 34 on mbus0
uart1: [FILTER]
ehci0: <Marvell Integrated USB 2.0 controller> at mem 0xf1050000-0xf1050fff irq 48,19 on mbus0
ehci0: [FILTER]
ehci0: [ITHREAD]
usbus0: EHCI version 1.0
usbus0: set host controller mode
usbus0: <Marvell Integrated USB 2.0 controller> on ehci0
mge0: <Marvell Gigabit Ethernet controller> at mem 0xf1072000-0xf1073fff irq 12,13,14,11,46 on mbus0
mge0: Ethernet address: 00:50:43:01:4c:b6
miibus0: <MII bus> on mge0
e1000phy0: <Marvell 88E1116R Gigabit PHY> PHY 0 on miibus0
e1000phy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 1000baseT-master, 1000baseT-FDX, 1000baseT-FDX-master, auto
mge0: [ITHREAD]
mge0: [ITHREAD]
Timecounter "CPU Timer" frequency 200000000 Hz quality 1000
Timecounters tick every 1.000 msec
usbus0: 480Mbps High Speed USB v2.0
ugen0.1: <Marvell> at usbus0
uhub0: <Marvell EHCI root HUB, class 9/0, rev 2.00/1.00, addr 1> on usbus0
uhub0: 1 port with 1 removable, self powered
Trying to mount root from ufs:/dev/ufs/sheevaroot
ROOT MOUNT ERROR:
If you have invalid mount options, reboot, and first try the following from
the loader prompt:
set vfs.root.mountfrom.options=rw
and then remove invalid mount options from /etc/fstab.
Loader variables:
vfs.root.mountfrom=
vfs.root.mountfrom.options=
Manual root filesystem specification:
<fstype>:<device> Mount <device> using filesystem <fstype>
eg. ufs:/dev/da0s1a
eg. cd9660:/dev/acd0
This is equivalent to: mount -t cd9660 /dev/acd0 /
? List valid disk boot devices
<empty line> Abort manual input
mountroot>