Hallo Zusammen,
ich versuche ein FreeBSD 11.2 mit WLAN zum laufen zu bekommen.
pciconfig -lv gibt folgendes zu WLAN Karte aus:
die /boot/loader.conf sieht wie folgt aus:
Kernel Modul: iwm8265 habe ich auch versucht... leider auch ohne Erfolg
folgende iwm Kernel Module sind geladen:
dmesg spuckt diese hier aus:
was mach ich da falsch ?
Danke
ich versuche ein FreeBSD 11.2 mit WLAN zum laufen zu bekommen.
pciconfig -lv gibt folgendes zu WLAN Karte aus:
Code:
iwm0@pci0:1:0:0: class=0x028000 card=0x00508086 chip=0x24f38086 rev=0x3a hdr=0x00
vendor = 'Intel Corporation'
device = 'Wireless 8260'
class = network
die /boot/loader.conf sieht wie folgt aus:
Code:
kern.geom.label.disk_ident.enable="0"
kern.geom.label.gptid.enable="0"
zfs_load="YES"
if_iwm_load="YES"
iwm8000Cfw_load="YES"
Kernel Modul: iwm8265 habe ich auch versucht... leider auch ohne Erfolg
folgende iwm Kernel Module sind geladen:
Code:
4 1 0xffffffff825c5000 28ee8 if_iwm.ko
5 1 0xffffffff825ee000 206ae0 iwm8000Cfw.ko
dmesg spuckt diese hier aus:
Code:
iwm0: <Intel(R) Dual Band Wireless AC 8260> mem 0xe1100000-0xe1101fff irq 16 at device 0.0 on pci1
iwm8000Cfw: root not mounted yet, no way to load image
iwm0: could not read firmware iwm8000Cfw (error 0)
iwm0: SecBoot CPU1 Status: 0x1, CPU2 Status: 0x3
iwm0: Failed to start INIT ucode: 35
iwm0: <Intel(R) Dual Band Wireless AC 8260> mem 0xe1100000-0xe1101fff irq 16 at device 0.0 on pci1
iwm8000Cfw: root not mounted yet, no way to load image
iwm0: could not read firmware iwm8000Cfw (error 0)
iwm0: SecBoot CPU1 Status: 0x1, CPU2 Status: 0x3
iwm0: Failed to start INIT ucode: 35
iwm0: <Intel(R) Dual Band Wireless AC 8260> mem 0xe1100000-0xe1101fff irq 16 at device 0.0 on pci1
iwm0: hw rev 0x200, fw ver 22.361476.0, address e4:a4:71:xx:xx:xx
iwm0: <Intel(R) Dual Band Wireless AC 8260> mem 0xe1100000-0xe1101fff irq 16 at device 0.0 on pci1
iwm0: hw rev 0x200, fw ver 22.361476.0, address e4:a4:71:xx:xx:xx
was mach ich da falsch ?
Danke